Removing a Semitool Rotor
NOTE: The Nitrogen (N₂) supply and the controller must be activated for the Rotor Stop Positioner (RSP) to engage properly during this procedure.
In this article, we walk you through the step-by-step process of removing and reinstalling a Quick Disconnect (QD) rotor from a SITEK / Semitool / Rhetech Spin Rinse Dryer with a brushless motor.
Prefer watching instead?
Check out our full video guide below for a step-by-step demonstration:
Tools You’ll Need:
- QD T-handle wrench (recommended for better leverage)
- OR standard Allen wrench
Rotor Removal Steps:
- Power Down and Confirm Readiness
- Ensure the tool is powered down and the chamber is safe to work in.
- Insert QD Wrench
- Insert your QD T-handle wrench into the center bolt of the rotor.
- Unscrew the Rotor Bolt
- Turn the bolt counterclockwise to loosen.
- Once loose, finish unscrewing by hand and remove the QD bolt.
- Support the Rotor
- Place your forearms on the bowl edge to support the rotor’s weight.
- Gently lift and remove the rotor without letting it contact the bowl.
- Inspect the Rotor
- Check for the alignment pin on the QD stem.
- Set aside the rotor for PM, balancing, or replacement as needed.
Rotor Reinstallation Steps:
- Locate the Motor Slot
- Identify the alignment slot inside the brushless motor hub.
- Align and Insert the Rotor
- Use your elbows/forearms to support and guide the rotor back into place.
- Gently spin the rotor while applying light pressure until the alignment pin clicks into the slot.
- Insert and Tighten the QD Bolt
- Reinsert the QD bolt and turn by hand until flush.
- Tighten the bolt another 15° with your wrench for a secure fit (do not over-tighten).
- Check Fitment
- Ensure the rotor sits securely and rotates properly.
- Slide your cassette into the chamber to confirm everything aligns.
⚠️ Caution:
If you experience resistance while removing the rotor, do not force it. Forcing the rotor out may damage the bowl or motor. Instead, contact SITEK immediately — we offer safe removal services and repairs for damaged rotors and motors.
Need help servicing your SRD?
📞 +1 916-797-9000
✉️ sales@sitekprocess.com
We repair and support Semitool, Verteq, and SITEK Spin Rinse Dryers, and we carry all the spare parts you need.
For more tutorials and maintenance tips, follow us on YouTube:
www.youtube.com/@sitekprocesssolutions3279
