|
Description: Motor, Brush Type, W/Tapper 8 3/8" shaft, 1/2 HP, (Re-Manufactured), 90VDC
(SRD-06-00128-RM)
Re-Manufactured Brush motor (1/2 hp) for Semitool "ST and F" model SRD's
* Motor has a stepped type motor shaft and used with Semitool "ST" or "F" model SRD's
when a tappered rotor drive plate is installed.
* Motors are 1/2 horsepower, 3800RPM, 90VDC, 5.7AMPS.
* Motor is sold as "Re-Manufactured". This work is completed:
New armature rewind
New brushes replaced
New bearings replaced
Motor casing is freshly painted
Motor is re bench tested after build.
Note: Motor is also available new under part number 06-00128.
Note - This motor 06-00128RM, may not be compatable with some ST 280 or ST 2300 models that are constructed with single piece front and rear motor brackets welded to assembly base. The motor on this one piece type build has a shaft length of 8 1/8" where as the motor listed above has a shaft length of 8 3/8". The 1/4" difference will not allow drive plates to locate correctly if mismatched. The motor with 8 1/8" shaft can also be identified by a flange mounted to both front and back of motor. See Part # 06-00949R. 07-211200
Can be used on 110V and 220V systems
Past possible OEM #: ST17359-01, SR3615-5308
Possible part #07-211200
|
Privacy Policy